by SolidAir » Fri Jul 21, 2023 12:07 am
Moving the foot 20mm will have relatively little effect on the measurement of the rake (as long as the shrouds stay the same length). The mast rake 'pivots' at the shroud point, which is maybe 2/3 of the way up, so the rake change should only be around 7mm. That's well within a sensible margin of error, i.e. how tight you have the tape measure, exact gudgeon position, rig tension and so on.
Also, have a look at the Top 10 settings on the website - you'll see quite a variety of settings to choose from!
Long story short, you should still be fine with 6050 at about 60-80 lbs tension.